- Sitop PSU8600 becomes an uninterruptible DC power supply
- Universal application scope in the manufacturing and process industries
- Simple integration in TIA and open automation systems with OPC UA
The DC UPS module can be simply integrated into the system network of the Sitop PSU8600 using the System Clip Link. The battery module is installed by means of wall mounting outside the network and connected to the UPS8600 over a plus and minus wire and the two wires of the Energy Storage Link. This allows the system to automatically detect the battery type and diagnose the battery charge status. The smart battery management system permits temperature-led charging, which helps to extend the service life of the battery. The battery modules are fitted with lead (PB) or lithium iron phosphate (LiFePO4) batteries with a capacity of 380 Wh (Watt hours) and 264 Wh respectively. Users are able to connect up to five BAT8600 battery modules to one UPS8600 to further increase the mains power failure bridging time. The BAT8600 battery module using lithium technology offers a particularly long service life, even at higher ambient temperatures.
The DC UPS is able to communicate with practically any automation system at any time through the base PSU8600 module, which has Profinet and OPC UA capability. Users can respond directly to messages and diagnostic information about the operating mode (mains or buffer operation), charge status, buffer readiness, or the need to change a battery. Integration in the network allows several PCs to be safely powered down with the UPS8600. Engineering takes place with the utmost convenience in the TIA Portal, while diagnostic functions use WinCC Faceplates or the Simatic PCS 7 Library. For open integration over Ethernet or OPC UA, new software is currently in preparation which enables convenient system-independent engineering, operation and observation.
For further information on Siemens at the Hannover Messe 2018, please see www.siemens.com/press/hm18 and www.siemens.com/hannovermesse.